Tsurumi Pump - Submersible NH

Tsurumi-NH-series is a cast iron made, submersible wastewater pump utilizing 2-pole
motor. This impeller is a shrouded two-channel impeller. Each channel is
designed to have a larger area and it enables the pump to be suitable for
pumping wastewater containing a certain size of solids. The pumps are available in six
motor sizes ranging from 1.5 to 7.5kW and available in either High-Head or High-Volume Type

Applications

• Draining wastewater from kitchen at a hotel, restaurant, and
hospital, etc.
• Drainage from factory,

underground

car park, and basement, etc.
• High-head pumping of wastewater containing solid matters

 

1. Anti-wicking Cable Entry

An anti-wicking block is provided at the cable entry
Tsurumi-NH-Cablesection of the motor chamber. Even if the cable jacket
becomes damaged or the tip of the cable is accidentally
immersed in water, this device prevents water from traveling
into the motor chamber through capillary action.

2. Motor Protector

A built-in thermal motor protection device reacts to the excessive heat
caused by overcurrent or run-dry conditions. It not only cuts off the
motor circuit automatically but also resets by itself. When the motor
cools down to a safe operating temperature, the motor restarts

3. Dual Inside Mechanical Seal

A mechanical seal with dual seal faces containing silicon carbide (SiC)
is equipped with the oil chamber. As both upper and lower sealing
faces are lubricated by the oil only, it ensures a longer life of the
product and a stable sealing effect.

4. Oil Lifter (Patented)

Tsurumi-NH-OilThe Oil Lifter is a lubricating device that forcibly lubricates the mechanical
seal. It further stabilizes the functions of the mechanical seal and
extends the life expectancy of the seal and also the maintenance term.

5. Air Release Valve

In order to prevent “air lock”, an air release valve is built in the pump
casing. The valve is similar to a ball check valve. When air goes
through the valve, the ball stays at the bottom, but when the pumped
water starts to flow, it closes the outlet by its buoyancy.

6. Seal Pressure Relief Port (5.5 & 7.5kW only)

A small chamber is provided between the oil seal and the shaft hole of
the pump casing, and this chamber is led to the outside by this hole.
With this device, the pumping pressure does not act on the mechanical
seal. The mechanical seal is protected from over rated limit.

 

Guide Rail Fitting System

The guide rail fitting system connects the pump to and
Tsurumi-NH-Guide railfrom the piping easily just by lowering and hoisting the
pump, allowing easy maintenance and inspection without
the need to enter the sump.
The TOS is the standard guide rail fitting system made of
cast iron and is compatible with cast iron pumps.

Accessories

• Duckfoot Bend
• Guide Support
• Guide Hook
• Lifting Chain 5m (with Shackles)
• JIS 10kg/cm2 Flange

Related posts

Leave your comment

Your Name: (required)

E-Mail: (required)

Website: (not required)

Message: (required)

Send comment

You might also likeclose